Dell Dimension 4500, Owner'S Manual

Page: 66 / 142

66
A d d i n g Pa r t s
www
.dell.com | support.dell.com
8
After the hinge arms snap into place, lower and raise the arms two or
three times to properly seat them.
9
Reattach the front-panel insert.
10
Reconnect the power cable to your computer.
11
Reattach the front door as described on page 62.
CAUTION: Before you begin any of the procedures in this section,
follow the safety instructions on page 9.
CAUTION: To guard against electrical shock, always unplug your
computer from the electrical outlet before opening the cover.
1
Shut down the computer (see page 22).
NOTICE:
To disconnect a network cable, first unplug the cable from your
computer and then unplug it from the network wall jack.
2
Turn off any attached devices and disconnect them from their
electrical outlets.
3
Disconnect the computer power cable from the wall outlet, and then
press the power button to ground the system board.
NOTICE:
Ensure that there is sufficient space to support the open cover—at
least 30 cm (1 ft) of desk top space.
4
Lay the computer on its side so that the arrow on the bottom of the
computer points up.
5
Locate the two release buttons shown in the illustration.Then, press
the two release buttons as you lift the cover.