Dell Color Laser Printer 2130cn, Service Manual

Page: 288 / 900

1 - 262
Chapter 1 Troubleshooting
FIP-1. 56 Paper Jam 077-901
Step Check
Remedy
Yes No
Possible causative parts:
CLUTCH ASSY DRV (PL3.1.1)
HARN ASSY L SIDE (PL3.1.18)
ACTUATOR REGI ROLL (PL3.2.8)
ROLL ASSY REGI (PL3.2.9)
ROLL REGI METAL (PL3.2.10)
ACTUATOR REGI IN (PL3.2.11)
SENSOR PHOTO (PL3.2.13)
TRANSFER ASSY (PL6.1.7)
DRIVE ASSY MAIN (PL7.1.2)
PWBA MCU (PL8.2.13)
HARN ASSY MAIN MOT (PL9.1.7)
HARN ASSY KSNR REGCL (PL9.1.9)
1
Checking the paper size
Does the using paper size meet the specification?
Go to step 3.
Use the paper that
meets the
specifications,
then go to step 2.
2 Does the error still occur when printing? Go to step 3. End of work.
3
Checking the paper condition
Is the paper wrinkled or damaged?
Replace the paper
with a new and dry
one, then go to
step 4.
Go to step 5.
4 Does the error still occur when printing? Go to step 6. End of work.
5
Checking after reloading a new paper
Reload a new paper.
Does the error still occur when printing?
Go to step 6. End of work.
6
Checking the COVER ASSY FRONT for latching
Open and close the COVER ASSY FRONT, and then latch
correctly.
Does the error still occur when printing?
Go to step 7. End of work.
7
Checking around the Regi Sensor
Are there any remaining paper and/or foreign substance
around the Regi Sensor? Remove the paper
and/or substance,
then go to step 8.
Go to step 9.
8 Does the error still occur when printing? Go to step 9. End of work.
9
Checking the TRANSFER ASSY
Are there any remaining paper and/or damage on the belt of
the TRANSFER ASSY?
Remove the
remainig paper. If
the belt is
damaged, replace
the TRANSFER
ASSY. (Refer to
Removal 21/
Replacement 33.)
Go to step 10.
10
Checking the ROLL ASSY REGI and ROLL REGI METAL
for shape and operation
Remove the PHD ASSY once to check the followings.
Are ROLL ASSY REGI and ROLL REGI METAL seated
correctly?
Also, are they not contaminated and/or damaged, and
rotated smoothly?
Check these items by turning with your finger.
Go to step 11.
Clean or replace
the defective
ROLL(s).