警示
:
許多維修僅可由獲得認可的維修技術人員來完成。
您
只能依照
產
品說明文件中的授權說明或在線上或電話服務和支援團隊
的指導下，執行故障排除和簡單的維修。由未經
Dell
授權的維修造成的損壞不在保固範圍之內。請閱讀並遵循隨
產
品寄送的安
全指示。
警示
:
To prevent damage to the control panel flex cable, do not bend the control panel flex cable after it is inserted into
the connector.
步驟
1. Use the hooks on the chassis as guides to align the HDD backplane.
2. Lower the HDD backplane until the release tabs snap into place.
3. Connect the SAS/SATA/SSD data, signal, and power cable(s) to the backplane.
後續步驟
1. Replace the cooling-fan assembly.
2. Replace the cooling shroud.
3. Install the HDDs in their original locations.
4. Complete the tasks listed in the After working inside your system section in this document.
相關工作
Before working inside your system
After working inside your system
相關參考
Removing the optional HDD backplane (back)
事前準備作業
1. Ensure that you read the Safety instructions section in this document.
2. Complete the tasks listed in Before working inside your system section in this document.
3. Remove both HDDs.
警示
:
許多維修僅可由獲得認可的維修技術人員來完成。
您
只能依照
產
品說明文件中的授權說明或在線上或電話服務和支援團隊
的指導下，執行故障排除和簡單的維修。由未經
Dell
授權的維修造成的損壞不在保固範圍之內。請閱讀並遵循隨
產
品寄送的安
全指示。
警示
:
To prevent damage to the drives and backplane, you must remove the HDD from the system before removing the
backplane.
警示
:
You must note the number of each HDD and temporarily label them before removal so that you can replace them in
the same locations.
步驟
1. Disconnect all the cables from the backplane.
2. Lift the release pin and slide the backplane toward the front of the chassis.
3. Lift the backplane to remove it from the chassis.
106
Installing and removing system components
