Item
Indicator, button, or
connector
Icon
Description
Four integrated connectors that include:
•
Two 10/100/1000 Mbps NIC connectors
•
Two 100 Mbps/1 Gbps/10 Gbps SFP+/10 GbE T connectors
10
Power supply unit (PSU1)
AC
750 W, or 1100 W
Or
DC
750 W or 1100 W
11
Power supply unit (PSU2)
12
vFlash media card slot
Allows you to insert a vFlash media card.
13
HDD (2) (back)
Up to two hot-swappable 2.5-inch HDDs.
Front-panel features and indicators
圖
2. Front-panel features and indicators (twelve 3.5-inch HDD chassis)
表
2. Front-panel features and indicators
Item
Indicator, Button, or
Connector
Icon
Description
1
Diagnostic indicators
The diagnostic indicators glow to display error status.
2
System identification button
The identification buttons on the front and back panels can be
used to locate a particular system within a rack. When one of these
buttons is pressed, the system status indicator on the back flashes
until one of the buttons is pressed again.
Press to toggle the system ID on and off.
If the system stops responding during POST, press and hold the
system ID button for more than five seconds to enter BIOS
progress mode.
To reset the iDRAC (if not disabled in F2 iDRAC setup), press and
hold the button for more than 15 seconds.
3
Power-on indicator, power
button
The power-on indicator glows when the system power is on. The
power button controls the power supply output to the system.
註
:
在
ACPI
相容的作業系統上以電源按
鈕
關閉系統，系統將
執行溫和關機，接著才會切斷系統電源。
4
NMI button
Used to troubleshoot software and device driver errors when
running certain operating systems. This button can be pressed
using the end of a paper clip.
8
About your system
