Delem DA-66T, Reference Manual

Page: 158 / 218

V0913, 9.20
Lock touch screen when started
To enable the locking of the touchscreen while the controller is started.
Pressure correction
Percentage of calculated force which actually controls the pressure valve.
Clamping correction
The position of the beam at which the sheet is clamped, is calculated. In order to have a
firm clamped sheet it is possible to offset the calculated pinch point with the value here
programmed. A positive value will result in a deeper position, a negative value in a
higher position of the beam.
Default part support return speed
Return speed of the part support after a bending. The speed value is programmed as a
percentage of the maximum speed.
Only available when there is a part support on the system.
Part support extra angle
Extra angle for the part support unit. This angle value is added to the part support angle
position at the end of decompression. So while the pressbeam moves up to its upper
dead point, the part support moves to this angle. When the beam has reached upper
dead point, the part support will move back to zero.
Only available when there is a part support on the system.
Intermediate X for Z-movement
Temporary safe value for the X-axis, to avoid collision as a result of movement along the
Z-axis. With this parameter a standard safety zone for the X-axis is defined, which is
valid for all programs. The value 0 disables this functionality. This parameter should not
be confused with the parameter ’X-safety’ of each die.
This parameter is especially useful when several dies of different sizes are placed on
the machine. In that situation, this intermediate X-value should be larger than the safety
zone of the largest die that is installed.
When the back gauge has to move to a different Z-position, it is checked whether the current
X-position is safe. We can distinguish the following situations:
•
Old X-axis position as well as new position outside the zone: X- and Z-axis movements
happen at the same time, no change.
• Old X-axis position outside, new position inside the zone: back gauge is positioned on
Z-axes first, the X-movement starts when the Z-axes are in position.
• Old X-axis position inside, new position outside the zone: back gauge starts along X-
axis, Z-movement is started when X-axis is outside the zone.