Delem DA-66T, Reference Manual

Page: 14 / 218

V0913, 1.8
Value Setting
Once the product or tool is drawn in the Sketching method the exact values of line lengths and
angles can be optimized by the Value setting method. Just tap 2 times on the value of the line
length or angle to change and the keyboard will pop-up. The value can be entered in 2 ways
of confirmation:
• Enter function
• Enter-Next function
The Enter function will close the keyboard after entering the value. The Enter-Next function
will enter the value on the line or angle to change and the keyboard will remain opened for the
next programming step.
In case the typed value is erroneous, the “undo” button right from the input field can be tapped
to return to the original value or the backspace key on the keyboard to delete the last typed
character.
Zoom Function
By pinching the screen with two fingers simultaeously one can zoom in and out on the
drawing, tool or machine visualisation. By spreading fingers the system will zoom-in, by
bringing fingers nearer to each other the system will zoom-out.
Fit-To-Screen
In the command icons on the side of the screen you will find a Fit-To-Screen function. This can
be used when the drawing size is not clear in picture. Just tap once and the complete drawing
will be sized to fit the drawing screen.
Panning
With simultaneous touching of two fingers and draging them over the screen (sliding in the
same direction) one can pan the object in 3D view. In 2D a single finger will also enable
panning.
Rotating
In 3D, rotating the product, tool or machine visualisation, can be done with a single finger
sliding over the screern.
More information about this can be found in chapter 3.
Features of the drawing tool
• Graphical design of product shapes in 2D and 3D (if available)
• Scaled sheet thickness
• Auto scaling
• Horizontal and vertical projected dimensions can be entered
• Real scale tool design
• Various machine shapes (pressbeams and tables)
• Changing of lengths and angles
• Adding or deleting of bends
• Special bend features can be applied
• Hemming bends can be programmed
• Bumping bends can be used for big radius
• Existing products can be copied, changed and stored as a new product
• Closing dimension or highest precision tolerance selection
• Connecting 2D programs for 3D-production