Delem DA-66T, Reference Manual

Page: 128 / 218

V0913, 8.6
Gauges
Auxiliary axis
If you have one or more auxiliary axes (for instance an X-axis, R-axis, Z-axis or part
support) the parameters of these axes appear here. When you have a R1-axis and a R2
axis the programmed R1 value is automatically copied to the R2-axis value. The R2-axis
value can, if necessary, be changed afterwards.
Retract
The retract distance of the axis during the bend. The "backgauge retract" is started at
the pinching point.
Speed
Speed of the axis in the current bend. Speed can be programmed in a percentage of the
maximum possible speed.
G-corr. PS
This is a general correction on the angle position of the part support. It is valid for all
bends.
The correction is programmed here as an angle value, relative to the part support angle of the
current bend. The correction is remembered as a percentage of the current angle. If another
bend is programmed or selected with a different angle, the correction value will be adjusted
accordingly. (Only available if a part support is present).
PS return speed
Return speed of the part support after a bending. The speed value is programmed as a
percentage of the maximum speed.
(Only available if a part support is present.)
The above mentioned parameters can be programmed and modified as required. After
pushing the Start button the programmed parameters are active.