Delem DA-66T, Reference Manual

Page: 109 / 218

V0913, 7.3
corrections will be saved in the active bending program.
The auxiliary axis correction should be entered as following examples indicate:
Programmed value of 200 millimetres.
Measured value of 202 millimetres.
->
Then it is required to program a correction of -2.
Programmed value of 200 millimetres.
Measured value of 198 millimetres.
->
Then it is required to program a correction of +2.
deflect
Correction on the crowning device.
Only available if a crowning device is present
General corrections
Angle
General correction of the angle, valid for each bend of the program. The value should be
programmed in the same manner as for the correction per bend.
Depth
General correction on the Y-axis position, in case ’absolute programming’ is used and
’air bend’ is selected for a bend. This correction is valid for each bend of the program.
Part support
This is a general correction on the angle position of the part support. It is valid for all
bends.
The correction is programmed here as an angle value, relative to the part support angle
of the current bend. The correction is remembered as a percentage of the current angle.
If another bend is programmed or selected with a different angle, the correction value
will be adjusted accordingly.
(Only available if a part support is present.)
X-axes
General correction of the X-axis position, valid for each bend of the program. The value
should be programmed in the same manner as for the correction per bend.
deflect
General correction on the crowning device.
Only available if a crowning device is present.
General
Step mode
Select to use either Auto mode (disabled) or Step mode (enabled). In Step mode you
have the same possibilities as in Auto mode. There is only one difference. After each
bend cycle, the control will stop. To continue working, you must start the control again by
pressing the Start button on the front panel of the control.
Stock
The stock counter is incremented or decremented after each end of a program cycle.