66
➡
If the spark igniters become
clogged, clean them using a
small, stiff-bristled brush (non-
metallic bristles).
➡
The gas injector is located in
the depression in the centre of
the burner. Be careful not to
obstruct it during cleaning, as
this will undermine the
performance of your hob. Use a
safety pin to unblock the injector
if necessary.
— In the event that a crack becomes visible in the glass worktop, immediately unplug
the appliance to avoid an electric shock and contact the After-Sales Service
department.
Thermocouple
Nut
Injector
Spark
igniter
PRODUCTS/ACCESS
ORIES TO USE
✓
Small, hard-bristled brush.
✓
Gentle scouring cream.
✓
Cleaning sponge.
It will be easier to maintain your hob if you clean it
before it has completely cooled down
.
However, never clean your appliance while it is in operation. Set all the controls to zero.
WHAT TO DO?
➤
Maintaining
spark igniters and
injectors
➡
For tough stains, use a non-
abrasive cream, then rinse with
clean water. Carefully wipe each
part of the burner before using
your hob again.
➤
Maintaining
pan supports and
gas burners
✓
Cleaning sponge.
✓
Special vitroceramic glass
products (e.g.:
➡
Clean with warm water and
then wipe. For tough stains, use
special vitroceramic glass
cleaning products.
➤
Maintaining the
glass top
✓
Cleaning sponge.
✓
Special glass vitroceramic
products (you can obtain
cleaning products from your
after-sales service department).
➡
Clean with warm water and
then wipe. If necessary finish
with the scouring side of a
sponge then wipe. For tough
stains, use special glass
vitroceramic products (see
examples opposite)
➤
Maintaining the
induction zones
— We recommend cleaning the hob fittings by hand rather than in a dishwasher.
— Do not use an abrasive sponge to clean your hob.
— Do not use a steam cleaner.
EN
4
4 // DAILY CARE OF YOUR APPLIANCE
