Programming the KFQSA Adapter
Enter the SHOW command to display what has just been entered:
? SHOW
Node
CSR Address
Model
0
772150
21
1
760334
21
2
760340
21
7
-------- KFQSA ------
?
To delete an entry from the table, use the CLEAR command. For example, to
delete the entry for node 2, enter CLEAR 2 at the prompt.
When finished, enter the EXIT command to write the entries to the
configuration table.
? EXIT
programming the KFQSA ...
>>>
After programming the configuration table, check that the bus node ID
plugs on the drive front panels correspond to the numbers that have been
programmed into the KFQSA. Set the KFQSA to NORMAL mode by setting
switch 1 to off (switches 2-4 have no effect when switch 1 is set to off).
Enter SHOW QBUS to verify that the configuration is as desired. You may
need to program DSSI parameters for the ISEs. Refer to Section 3.8.3.1 for
instructions on setting DSSI parameters.
Programming the KFQSA Adapter H–5
