KA681/KA691/KA692/KA694 Firmware Commands
A.2 Console Commands
A.2.2 CONFIGURE
The CONFIGURE command invokes an interactive mode that permits you
to enter Q22–bus device names, then generates a table of Q22–bus I/O
page device CSR addresses and interrupt vectors. CONFIGURE is similar
to the OpenVMS SYSGEN CONFIG utility. This command simplifies field
configuration by providing information that is typically available only
with a running operating system. Refer to the example below and use the
CONFIGURE command as follows:
1. Enter CONFIGURE at the console I/O prompt.
2. Enter HELP at the
Device,Number?
prompt to see a list of devices whose
CSR addresses and interrupt vectors can be determined.
3. Enter the device names and number of devices.
4. Enter EXIT to obtain the CSR address and interrupt vector assignments.
The devices listed in the HELP display are not necessarily supported by the
CPU.
KA681/KA691/KA692/KA694 Firmware Commands A–15
