457
Lamborghini Countach LP 500S
Place the front fender (Stage 77) upside
down on a soft cloth. Move the LED
cables to the sides, as shown, and then
align the holes in the front compartment
with those indicated in the front fender.
7
Tighten a 2.6 × 6mm screw (Stage 78)
into each of the three holes indicated
above to secure the front compartment
to the front fender.
8
Align the left door hinge at the front of
the left door (Stage 75) with the
corresponding hole in the rear of the
front fender.
Repeat Steps 10 and 11 to fit the right
door (Stage 78) to the front fender.
Push the hinge into the hole in the fender
at the angle shown, then slowly lower the
door into place.
Insert the tip of the screw into the end of
bracket A and tighten into place.
Place the front fender face up, and
temporarily apply masking tape
over the headlamps to prevent them
from opening.
Insert a 2 × 5mm self-tapping screw with
washer (Stage 78) through the hole at the
end of the bonnet stay (Stage 72).
10
12
11
6
9
5
Summary of Contents for MODEL SPACE Lamborghini Countach LP 500S
Page 1: ...WALTER WOLF MODEL Pack 24 ...
