CBT36K Assembly Manual
Page
48
of 89
8.3.6.
Glue Tweeter Resistors to PC
Board:
Glue the Tweeter Module resistors and, verify the
resistor values:
1)
PCB 18 - 1.0
2)
PCB 16 - 1.5
3)
PCB 14 - 2.5
4)
PCB 11 - 1.5//1/5
8.4.
D
RESS
W
IRING FOR
ND91
M
ID
-B
ASS
D
RIVERS AND
T
WEETERS
:
8.4.1.
Bend the Jumpers:
Bend jumpers so they curve in toward the drivers.
Longer jumpers will route across the back of the
magnets.
8.4.2.
Unroll the Speaker Caulk:
Unroll the speaker caulk and pull off a 2 inch
length.
8.4.3.
Wrap the Caulk Around Jumper:
Wrap the caulk around the long jumpers as shown.
8.4.4.
Press the Caulked Wire to the
Magnet:
Press the caulk against the magnet and form a
mound to hold the wire securely. Do not allow the
caulk to enter the magnet hole.
8.4.5.
Caulk the Rest of the Wires:
Work your way down the speaker caulking the
wires to the back of each of the magnets. At
locations with more than one wire, wrap the caulk
around all before bonding to the magnet.
8.4.6.
Hot Glue the Wires:
Hot glue the wires to driver 1 as shown. Repeat these steps for
the tweeter wires. Be careful not to get hot glue on the rear
surface of the mid bass cone.
