CBT36K Assembly Manual
7.2.1. Bank 1 Wiring Diagram:
1
2
3
4
5
6
To Speak-On Connector 12” jumper
Red 1+, Black 1-
To Bank 2 Input
Bank 1 Wiring Diagram
6” Gray
6” Red
15” Black
35” Red
6” Black
24” Black
17” Red
6” Red
6” Red
6” Gray
6” Black
6” Black
Use 18AWG wire for all BASS-MID wiring.
Fig. 9. Bank 1 wiring diagram for mid-bass drivers 1 to 6.
7.2.1.1. Insert Twisted Stranded Wire into Mid-Bass Terminals:
After twisting the wire to minimize stray strands, insert the wire into each terminal and leave the wire
straight. After all wires have been inserted, then go back and wrap them around the driver terminals.
7.2.1.2. After all Mid-Bass Jumper Wires are Installed, You Can Go Back and Wrap them Around the
Terminals:
This photo shows all the mid-bass jumper wires for drivers 1, 2, 3, and 4 installed but not soldered. Some
drivers have two wires in each terminal. After all wires are installed correctly, then go back and twist them
around the terminals in preparation for soldering. The next two photos illustrate proper wrapping
techniques.
Page
35
of 89
