CBT36K Assembly Manual
Page
24
of 89
5.5.
C
UT WIRE TO
L
ENGTH AND
R
EMOVE
I
NSULATION
:
5.5.1.
Cut Lengths for 18 AWG Wire:
Refer to the wire table, cut wire lengths for 18AWG
wire for MID-BASS drivers and Speakon connector
(
NOTE:
The wires shown above are for one
cabinet only.)
5.5.2.
Cut Lengths for 24 AWG Wire:
Refer to the wire table, cut wire lengths for 24AWG
wire for tweeter modules (
NOTE:
wire shown
above is for one cabinet only).
5.5.3.
Remove Insulation:
Remove insulation for each wire as designated in
the table. (
NOTE:
Some wires are tinned prior to
installation.)
5.6.
A
TTACH
W
IRES TO
R
ESISTORS
:
The following steps describe attachment of wires to
the shading resistors. (
Note:
Two sets of each of
the following resistor combinations must be
prepared for the left and right pair of CBT36s).
5.6.1.
Locate Parallel Resistors:
Locate parallel resistors configured as shown
above, all these are for MID-BASS drivers. Using
the following photo as a guide, connect wire as
follows:
1)
1.5//1.5 Ohm - 4” RED and 28” RED
18 AWG
2)
2.0//2.0 Ohm - 4” YELLOW and 4”
YELLOW 18 AWG
3)
3.0//3.0 Ohm - 4” YELLOW and 4”
YELLOW 18 AWG
4)
5.0//5.0 Ohm - 4” YELLOW and 11”
YELLOW 18 AWG (
NOTE:
These wires
are items 16 and 17 in the “18 AWG
Stranded Wire” table and have a tinned “J”
shape on one end. The “J”-shaped tinned
end does not connect to the resistor. The
un-tinned end of the wire does connect to
the resistor, see following photo for
clarification.)
5.6.2.
Connect the Wire to Resistors: