B
F/G
A
F / 2x
G / 2x
H/J
F / G
Miscellaneous
The
is not intended for use in damp rooms. Rust could develop, which would
damage parts of the device and impair both the operating functions and the safety features.
ergo_bike
The
uses a mains voltage of 230 Volt, 50/60 Hz and has a power consumption
of 50 Watt. The power supply you wish to use must fulfil these requirements!
ergo_bike
Install the
on a level floor. The manufacturer will not be held responsible for any
damage done to the floor. We thus recommend installing the device on a protective base.
ergo_bike
The cable of the handlebars support column must be driven into the column (after plugging
the connector) before inserting the column into the frame. Otherwise, the cable could be
crushed, which could lead to malfunctions of the ergo_bike!
Dashboard 4.1
(pre-installed)
Handlebars column 2
Handlebars 7
Dashboard cable 3
(black connector / CS)
Dashboard support 6
Handlebars column
fastening screws
Attention !!
Connector
Clamp 8.1
Saddle 13
Main device body 1
toggle button 12a
toggle button 12d
Saddle support 12
with horizontal
adjustment guide
Pedal 16/17
straps
with
16a/17a
Caster
Any fault or defect on the device that have an impact on safety must be repaired. Defective
or broken parts must be replaced immediately (see spare parts list page 51). The device is
not to be used until the repair is complete.
Tensing button 6a
(immobilising the handlebars)
E
21
ergo_bike
Assembly and maintenance
Installation hints
