![background image](http://html.mh-extra.com/html/daum-electronic/cardio-pro/cardio-pro_user-manual_514131030.webp)
28
Exchanging the Dashboard / Replacing the Battery
Required tools:
Phillips screwdriver / Blade 1 x 70 mm
Unplug the power cord!
(For your personal safety and to protect the sensitive electronic parts inside the dashboard)
1.
2.
The top part of the dashboard is secured to the bottom part by mean of 4 Phillips screws
(A, B, C, D). Use an appropriate screwdriver to unscrew these screws from underneath
the dashboard. (See the figure to the right) Please note that the screws C & D are located
toward the outward border and are deeply recessed in the dashboard bottom part. Do not
unscrew the nearby located screws (X)!
3.
Then you can remove the top part of the dashboard very carefully. First open the dashboard housing
by raising it from the higher side slightly and grasp (hold) with both hands underneath the top shell of
the dashboard. Raise the higher part of the dashboard top shell further until the lower side separates
from the dashboard support. Be careful to raise the top shell of the dashboard housing only until you
feel a slight resistance from the cables that are connected from underneath, and until you can reach
the connectors on the circuit board with your thumb and index finger.
4.
You must unplug both connectors.
Never pull on the cables to unplug them!! This would tear them off!
Never pull the cable!
It could tear off!
CAUTION!
Failure to correctly
replace the battery
may create an
explosion risk.
2.
3.
A
B
C
D
X
X
Dashboard
bottom part
Dashboard
support
Circuit
board
Dashboard
top part
Dashboard
top part
Dashboard
bottom part
4.
Be careful when pulling the connector in order
to avoid damaging the circuit board and
the electronic parts!
5.
Plug the dashboard connector and the hand pulse connector to the female connector of the corresponding colour until they
lock in position. Then pull carefully the two cables through the opening of the bottom part of the dashboard and the dashboard
support and take care not to jam the cables when you reinstall the top part of the dashboard on the bottom part.
6.
Screw the removed housing screws (A, B, C, D) from underneath the dashboard and tighten them.
7.
You can know plug the power cord, turn on the device and test its operation.
Replacing the dashboard battery
A button cell battery (CR 2032) is located on the underside of the dashboard circuit board.
This battery must be replaced when the time and date keeping function fails. Problems when
turning on the machine and display failures are also signs of an empty battery.
Warning: The device must be switched OFF when replacing the battery. Afterward you must
set the date and time.
Unscrew and remove the 4 screws on the lower part of the dashboard. Then tilt the upper part
of the dashboard up carefully.
Take care not to separate any cable connection.
Never touch the electronic parts of the dashboard with your fingers! Charges of static electricity
can destroy the sensitive parts.
Press the clip holder outward with a pin to replace the battery, remove the battery and insert
a new one with the plus symbol up.
Reassemble the upper part of the dashboard carefully.
Caution! Do not pinch any cable!
Notes about used button cell batteries
- Keep batteries away from children, and do not swallow them!
- Do not recharge empty batteries and do not throw them in fire.
Please recycle used batteries by bringing them to the appropriate collect point, or return them to your dealer.