Datex-Ohmeda S/5 FM, User Manual

Page: 81 / 94

79
79
MESSAGE CAUSE WHAT TO DO
NIBP manual NIBP: Air leak or loose cuff have interrupted the
autocycling mode
Check setup and restart autocycling.
No battery backup There are no batteries or they have both failed. Replace the batteries; see section “Replacing the
batteries.”
Noise ECG: Unreliable HR calculation or distorted waveform,
may occur during defibrillation or because of motion
artifacts.
Check the patient status. Check the electrodes.
No SpO2 probe SpO
2
: The probe is not properly connected to the
module.
Check connection between sensor and module.
No SpO2 pulse SpO
2
: Pulse signal is poor. Try other measuring sites.
No P1 transducer InvBP: Invasive blood pressure transducer or channel x
cable disconnected.
Connect the transducer or the cable.
Poor signal SpO
2
: Pulse signal is poor possibly because of low
perfusion.
Change measuring site.
'PSM' measurements removed Measurement module has been removed. Reconnect the module if you want to restart the
measurement.
RAM error Memory checking failed. Contact authorized service personnel.
Recorder module removed The N-FREC or N-FCREC module has been removed. Reconnect the module if you need a recorder.
Replace Battery A
Replace Battery B
There is hardly any charge left in one of the batteries.
Also check the symbol on screen.
Replace the battery as soon as possible; see
section “Replacing the batteries.”
Replace D-Fend Gases: The water trap is partially blocked. Replace the water trap.
Sample line blocked Gases: The gas sampling line is blocked or the water
trap is occluded.
Change sampling line and water trap.
Select inflation limits NIBP: You are using a hose without an automatic
identification. When you try to start the measurement,
the monitor goes automatically to the selection NIBP
Setup - Inflation Limits .
Select appropriate inflation limits. NOTE: AUTO
option is not available for these hoses.
Sensor INOP Gases: The gas measuring sensor is inoperative or the
temperature in the module has increased.
Contact authorized service personnel.