Datcon DT1400 RL2 IA, Operating Instructions Manual

Page: 30 / 72

DT1400 xx xx
30
20170920-V0
7.5. Decimal point position (03. menu item)
Function Setting the position of the decimal point on the display, or
switching the decimal point off.
[Default factory setting: 2 decimals]
Sequence of operations 1. Enter the menu with the supervisor code.
The way the code should be type in can be found in
Chapter
7.1. Typing the code in . You see on the display:

.
2. Keep stepping by pressing the ▲ button as long as you
see this menu item:

.( D ecimal P oint).
3. Enter the menu item by pressing the ENTER button.
4. You see this

on the display. The mnemonic is
blinking.
5. You can move the decimal point to the right by pressing
the
▲ button.
•


= 2 decimals [default factory setting]
•


= 1 decimal

•


= no decimals

•


= 4 decimals
•


= 3 decimals
Exit from the menu item 1. After finishing the settings, press the MENU button to exit
from the given menu item, and you see:

.
(2. If you want to change the settings you have done just
now, or if you just want to check what you have typed in, go
on with the operation from point 3 of the
Sequence of
operations .)
(3. If you don’t want to exit the menu (you want to do further
settings), then you may select the desired menu items by
pressing the
▲ button.)
Exit from the menu
1. Press the MENU button. First the mnemonic

( Save ), then the mnemonic

( Exit ) are shown on the
display. With this the storing of the settings is completed.
The instrument has exited the menu and goes on with the
measurement.