Datamax Prodigy Plus, Operator'S Manual

Page: 24 / 178

Printer Setup
16 Prodigy Plus
Char Description Format
m Set metric flag, enter metric mode All references set to metric until reset
O Form edge offset (start of print
position)
O nnnn = 4 digits, in/100 or mm/10
o Cycle cutter
P Enter character dump mode
p Controlled pause
Q Clear all memory modules
q Clear module q x = Module I.D. (Uppercase)
r Select reflective sensor Used for "black-strip" media sensing,
(e.g. continuous tags, butt-cut labels.
Stripe must be printed on back side of
media)
S Slew (feed) speed S x x = C-0, 2-8 ips
s Set up for one print buffer
T Printhead dot pattern test label
t Test RAM memory module
(Must be in Test Mode) a bbbK ‘Module Good’
A=1(top slot) B=2 (bottom slot)
bbb = 256 or 512, for size of module
U Label format field replacement
V Software switch settings Vn n = 4-Label Present, 2-color ribbon,
1-Cutter Enable
v Firmware version information Sends version string to Host
W Request memory module information Wx x = F-font, G-graphic, L-label
w Test FLASH module memory Takes about 90 seconds
X Set default module bank X a a - A = Memory Module A
Y Output sensor values Dumps sensor values status to
RS-232 port
Z Print internal information and dot
pattern
Table 2-3 System-Level Commands (Continued)