Dataman 40PRO, User Manual

Page: 38 / 168

38
Notes:
Pin no. 1 is signed by triangle scratch on ISP cable connectors .
As ISP connectors are used 20 pins connectors 09185207813 from Harting or other
compatible connector.
DATAMAN-48PRO2 / DATAMAN-48PRO2C ISP cable
Warnings:
When you use DATAMAN-48PRO2 / DATAMAN-48PRO2C as ISP programmer, don’t
insert device to ZIF socket.
When you program devices in ZIF socket, don’t insert ISP cable to ISP connector.
Use only attached ISP cable. When you use other ISP cable (other material, length…),
programming may occur unreliable.
DATAMAN-48PRO2 / DATAMAN-48PRO2C can supply programmed device (pin 1 of ISP
connector) and target system (pins 19 and 20 of ISP connector) with limitation (see
Technical specification / ISP connector).
DATAMAN-48PRO2 / DATAMAN-48PRO2C apply programming voltage to target device and
checks his value (target system can modify programming voltage). If the programming
voltage is different as expected, no action with target device will be executed.
Multiprogramming by DATAMAN-48PRO2 /
DATAMAN-48PRO2C
During installation of PG4UW at Select Additional Tasks window you check, if is allowed install
DATAMAN-48PRO2 / DATAMAN-48PRO2C multiprogramming control support.
For start of DATAMAN-48PRO2 / DATAMAN-48PRO2C multiprogramming is necessary run
special control program
pg4uwmc.exe . At this program user assign DATAMAN-48PRO2 /
DATAMAN-48PRO2C to control programs, may load projects for all DATAMAN-48PRO2 /
DATAMAN-48PRO2C and run PG4UW for every connected and assigned
DATAMAN-48PRO2 / DATAMAN-48PRO2C.
Selftest
If you feel that your programmer does not react according to your expectation, please run the
programmer (ISP connector) selftest using Diagnostic pod (Diagnostic pod for ISP connectors
#2), enclosed in the standard delivery package.