Datalogic Matrix 120, Product Reference Manual

Page: 50 / 188

INTRODUCTION
36 MATRIX 120™
If the autolearning cannot be reached after a timeout of about 3 (three) minutes, Matrix
120™ will exit without saving the parameters to memory, the Learn LED will stop blink-
ing and in this case Matrix 120™ emits a long low pitched beep.
You can exit the Learn function at any time by pressing the X-PRESS push button once.
After a short delay the Learn procedure is canceled.
Diagnostic Indication
The “STATUS” (red) and “READY” (green) LEDs blink simultaneously to signal the pres-
ence of an error. Diagnostic message transmission on interfaces can be enabled to pro-
vide details about specific error conditions. See the Diagnostic Error Conditions chart in
the Diagnostic page of the DL.CODE Monitor.
LED STATUS
Ready Blink
Good
Trigger
Com
Status Blink