Datakom D-500, User Manual

Page: 58 / 153

D-500 User Manual Rev_06 Firmware V-5.8
K35D05-EN - 58 -
STATUS LEDS:
AUTO READY : Turns on when the AUTO mode is selected and there is no condition preventing
engine start.
ALARM: Turns on when a shutdown alarm or loaddump condition exists.
WARNING: Turns on when a warning condition exists
SERVICE REQUEST: Turns on when at least one of the service counters has expired.
MODE LEDS: Each led turns on when the related mode is selected, either locally or remotely.
MIMIC DIAGRAM LEDS:
MAINS AVAILABLE: This led turns on when all mains phase voltages and the mains frequency
are within limits. If enabled, the mains phase rotation order must be also right. When any digital
input is defined as Remote Start, this led will reflect the status of the input. When a Simulate
Mains signal is present, then mains status will become “available”. When a Force to Start signal is
p
resent, then the mains status will become “not available”.
MAINS CONTACTOR ON: Turns on when the mains contactor is activated.
GENSET CONTACTOR ON: Turns on when the genset contactor is activated.
GENSET AVAILABLE: This led turns on when all genset phase voltages and the genset
frequency are within limits. If enabled, the genset phase rotation order must be also right.
If a Remote Start input is defined, then the Mains led will
reflect the input status.
Simulate Mains and Force to Start signals will also affect this
led.
9.6. LED LAMPS
AUTO READY
indicator
Shutdown
alarm indicator
TEST mode
indicator RUN mode
indicator
AUTO mode
indicator STOP mode
indicator
Warning
indicator
Service
request
indicator
Mains
Contactor
On led
Genset
available
led
Mains
available led
Genset
Contactor
on led