DataCard CR805, User Manual

Page: 136 / 136

A-14 CLM Laminator
f.
Laminator displays on line 2. Press E
NTER
.
g.
Start displays on line 2 of the LCD panel. Press E
NTER
to start
the cleaning process.
h.
Insert cleaning card displays on the LCD panel. Press the
U
SER
button to start the cleaning cycle.
The laminator pulls the cleaning card from the card exit slot into the laminator and moves it
back and forth through the L1 and L2 cartridge areas, the card entry area, and the exit rollers
several times. If the system has locks, the used card is ejected into the laminator reject tray. If
the system does not have locks, the used card is ejected into the laminator output hopper.
6.
Inspect the laminator cartridges for particles. If particles are present:
a.
Retrieve the laminator cleaning card and use it to remove the particles of overlay
material from the cartridges.
b.
If particles still remain on the cartridge and inside of the laminator, use a vacuum cleaner
with a small plastic hose attachment to carefully remove the particles. Also clean any
remaining particles from the output hopper.
H
INTS
& T
IPS

If the cleaning card is not pulled into the laminator, the card is not in the correct position. The
cleaning card must be located under the rollers of the card exit slot inside the output hopper.

At the end of the laminator cleaning cycle, the card can stick to the rollers in the output
hopper. Pull on the card to remove it.

Discard the cleaning card after one use.

Avoid contact with the heated roller, which contains sensitive electronic components.

If cleaning the laminator does not solve the problem, contact your service provider for
assistance.