46062-0299 <90-00016>
P
AGE
31
B
ELL
Purpose:
Reports if the terminal bell is on or off. Turns bell on or off;
when bell is on, it sounds when a change of alarm status occurs.
Format:
BELL
BELL ON
BELL OFF
Remarks:
The command BELL causes the current status of the BELL
feature to be displayed.
The other commands turn the bell on or off.
BEEP or DING can be substituted for BELL
Output Response:
Only the BELL command gives a response and that is to report
if the bell is on or off.
C
ALL
Purpose:
Establishes a communications path to a MAP’s printer port.
This allows access to the MAP’s Printer Syntax. Refer to the
MAP’s firmware manual for information about the MAP’s
syntax.
Format:
CALL #
Remarks:
Everything that you type is sent to the MAP.
To display the path, enter Ctrl-V and the command PATH after
the question mark.
To exit, enter Ctrl-V and the command DISCONNECT, which
will disconnect the path to the MAP.
The symbol # must be an individual MAP address. The possible
range of device addresses can be 1 through 32
PRINTER SYNTAX
