-22
-
OPE RA TI O N
IN STR U CT IO N
Speed dome can be driven through combination of
hot keys on a keyboard controller. It can also be
driven through OSD menu. OSD menu can be
activated by preset #95 call or double calling preset
1 (call twice within 5 seconds). Preset calling can be
done through a keyboard controller or any other
device (e.g. a computer) that can send proper
command to the speed dome.
OSD menu operations are specified as follow:
■
■
■
■
PREHEATING SCREEN
When power on the dome and system temperature
is under -15C/5F
，
，
，
，
following screen shows up:
System heats up till the system temperature is above
-15C/5F. System starts to boot up after heating up
finishes.
< Outer Temp >
Environment temperature XXC/XXF C=Celsius
；
；
；
；
F=Fahrenheit
< Inner Temp >
System inner temperature
< Fan Speed >
The rotating speed of fan
■
■
■
■
BOOT-UP SCREEN
When power on or restart the dome, the boot up
information will display on screen and then the
dome will conduct self-testing. “System booting
up…” will show on the screen until “boot-up
success” shows up. The whole boot up process lasts
about 40 seconds. This screen display disappears
once the dome receives any effective command.
<Protocol>
Dome control protocol.
<Baud Rate>
Dome control baud rate
<Camera ID>
The dome ID address set by dip-switch or keyboard.
(Refer to APPENDX I)
<Camera S/N>
Camera serial number
<Model>
Speed dome model number.
<Version>
Hardware and software version
Protocol
: Pelco D
Baud Rate : 2400BPS
Camera ID : 001
Camera S/N : 8888888888
Model : -------------
Version : 10.72
Outer Temp :022C/071F
System Tem:027C/080F
Fan Speed :6480rpm
Booting Up… …
Outer Temp :-030C/-022F
Inner Temp: -020C/-004F
Fan Speed :6480rpm
System Under -15C/5F
System Heating Up
Please Wait......
Protocol : Pelco D
Baud Rate : 2400BPS
Camera ID : 001
Camera S/N : 8888888888
Model : -------------
Version : 10.72
Outer Temp :022C/071F
System Tem:027C/080F
Fan Speed :6480rpm
Bootup Success