- 12
-
■
■
■
■
WALLMOUNT
Check carefully to make sure the wall is firm and does
not peel off. It is required that the wall can withstand 8
times weight of the dome set.
1.
Mark mounting position
Use bracket to mark the mounting position on wall.
2.
Install bracket.
Connect all cables through the hole of bracket, and fix
bracket on the wall.
NOTE: Put cables through the wall or aside the
bracket.
3.
Release the connection board.
Unscrew to release the circuit board on connection
board.
4.
Install housing
Connect cables through the hole on top of the housing.
Align the fast connector to bracket and fix with 2 M5
screws.
NOTE: Apply water-proof tape to the thread in the case
of outdoor dome
M 5 S C R E W
T A P E
5.
Connect cables.
Plug cables into corresponding sockets on circuit board.
Reinstall the circuit board and turn on the power. The
red LED is on if connections are correct. Turn off the
power after checking.
NOTE: Names of the interfaces are marked on terminal
block or PCB. Connect cables as picture shows. Make
sure power is off before connecting.
ALARM
VI DEO
RS485, AC24V