- 15
-
6.
Connect cables.
Plug cables into corresponding sockets on circuit
board. Reinstall the circuit board and turn on the
power. The red LED is on if connections are
correct. Turn off the power after checking.
NOTE: Names of the interfaces are marked on
terminal block or PCB. Connect cables as picture
shows. Make sure power is off before connecting
ALARM
VI DEO
RS485, AC24V
7.
Set dome ID, baud rate and protocol.
Set dome ID, bard rate and protocol by configuring
DIP switches (Refer to APPENDIX I).
S W 1
S W 2
8.
Lower cover preliminary installation.
Attach the safety chain with a M3 screw as picture
shows.
9.
Install black liner and Pan/Tilt Module.
Push the black liner into the two tabs. Install the
pan/tilt module with two clips, match color of AMP
sockets. Gently push the module upward until
hearing two clicks.
NOTE: Remove the lens cover.
S O C K E T
Tab
Bl ack Li ner
10.
Install lower cover.
Unscrew the two M4 screws on lower cover ring.
Push up the lower cover into the housing, and then
fasten lower cover with two M4 screws.
NOTE: Apply the lube to the O-ring in the case of
outdoor dome
lube
M4 slot