D4-12 Series Four-Post Lifts
37
P/N 5900246 — Rev. B — July 2021
To install the Return Line
:
1.
Measure the distance from the Return Line Port on the Hydraulic Cylinder to the Return Line Port
on the Power Unit.
2.
Cut a piece of Tubing to the measured length from the roll of Tubing that comes with the Lift.
It is better to cut the Tubing a little too long rather than a little too short.
3.
Route the Tubing from the Hydraulic Cylinder through the Flex Tube opening, and out next to
where the Power Unit will be installed.
4.
Remove the Shipping Plug from the Return Line Port on the Hydraulic Cylinder.
5.
Connect and tighten the Elbow Fitting (PN 5550089) into the opening where the Shipping Plug
was.
Use Thread Sealant on NPT threads only.
Drawing shows how to connect
the Return Line Fitting to the
Hydraulic Cylinder.
View is from underneath the
Powerside Runway, near Cylinder
end.
Not all components are shown.
6.
Connect one end of the Return Line to the COMP end of the Fitting.
Refer to
Working with Compression Fittings and Tubing
7.
Leave the Power Unit end of the Return Line hanging out of the Flex Tube opening for now.
It will be connected to the Power Unit later in the installation.
Summary of Contents for D4-12
