D4-12 Series Four-Post Lifts
17
P/N 5900246 — Rev. B — July 2021
To create Chalk Line Guides
:
1.
Create the Front Chalk Line where you want the Front of the Lift.
Make the Front Chalk Line
longer
than the
Overall Width
setting.
2.
Create the two Side Chalk Lines at 90° angles to the Front Chalk Line and parallel to each other.
Make the Side Chalk Lines longer than the
Outside Length
setting.
The Side Chalk Lines
must
be parallel to each other.
3.
Create the Rear Chalk Line parallel to the Front Chalk Line.
Make the Rear Chalk Line longer than the
Overall Width
setting.
The Front and Rear Chalk Lines
must
also be parallel to each other.
4.
Before moving the Posts into position, measure
diagonally
to make sure the two diagonal
measurements are the same.
Do not forget to check the diagonals.
5.
When you move the Posts into position, put the corners of the Base Plates inside the corners
created by the four Chalk Lines.
Unloading and Unpacking
Once the components are unloaded, they are your responsibility to move around. As the Lift includes a
number of heavy pieces, the closer you unload them to the installation location, the better off you are.
⚠
CAUTION
Some Lift components are very heavy; if handled incorrectly, they can damage
materials like tile, sandstone, and brick. Try to handle the Lift components twice:
once when delivered and once when moved into position. You must have a Forklift
or Shop Crane to move them into position. Use care when moving them.
⚠
WARNING
The Posts and Runways are delivered with stabilizing structures on each end. Be
very careful when removing these stabilizing structures; the Posts and Runways
can shift or even fall. If they fall on a person, they could cause serious injury.
Moving the Posts into Position
Use a Forklift or Shop Crane to move the Posts, one at a time, to the inside corners of the Chalk Line
Guides.
Important
: Position the Power Post at your chosen location. Remember, the Power Post can only
go in two possible locations: the
Front Driver-Side
or the
Rear Passenger-Side
.
Do not stand up the Posts yet
; some of the following procedures are easier to complete if the
Posts are laying on the ground.
Summary of Contents for D4-12
