D4-12 Series Four-Post Lifts
50
P/N 5900246 — Rev. B — July 2021
3.
Vacuum each hole clean.
Important
You must wear the proper eye
protection.
You can also use a wire brush, hand pump, or
compressed air; just
make sure to thoroughly
clean each hole
.
Do
not
ream the hole. Do
not
make the hole any
wider than the drill bit made it.
4.
Make sure the Washer and Nut are in place,
with the top of the Nut flush with the top of
the Anchor Bolt
, then insert the Anchor Bolt into the hole.
5.
Hammer or mallet the Anchor Bolt down into the hole; stop hammering when the Washer is snug
against the Base.
Use a hammer or mallet to get the Expansion
Sleeve through the Base and down into the hole.
Even using a hammer or mallet, the Anchor Bolt
should only go into the hole part of the way;
this is
normal
. If the Anchor Bolt goes all the way in with
little or no resistance, the hole is too wide.
Once past the hole in the Base, the Anchor Bolt
eventually stops going down into the hole as the
Expansion Sleeve contacts the sides of the hole;
this is normal
.
6.
Plumb each Post; install any needed Shims.
Do not shim a Post more than half an inch using the provided Shims. A maximum of 2 inches is
possible by ordering optional Shim Plates. Contact Dannmar at
1
(877) 432-6627
with the
model and serial number of your Lift.
7.
Wrench each Nut
clockwise
to the recommended installation torque, 85-95 pound feet, using a
Torque Wrench.
Wrenching the Nut forces the Wedge up, forcing out
the Expansion Sleeve and pressing it tightly against the
Concrete.
Important
: Do
not
use an impact wrench to
torque the Anchor Bolts.
Summary of Contents for D4-12
