It is recommended to do the set-up in the order listed.
Illustration 8.1: Quick menu view.
Par.
Designation
[Units]
0-01
Language
1-20
Motor Power
[kW]
1-22
Motor Voltage
[V]
1-23
Motor Frequency
[Hz]
1-24
Motor Current
[A]
1-25
Motor Nominal Speed
[RPM]
3-41
Ramp 1 Ramp up Time
[s]
3-42
Ramp 1 Ramp down Time
[s]
4-11
Motor Speed Low Limit
[RPM]
4-13
Motor Speed High Limit
[RPM]
1-29
Automatic Motor Adaptation (AMA)
Table 8.2: Quick Setup parameters
If
No Operation
is selected in terminal 27 no connection to +24 V on terminal 27 is necessary to enable start.
If
Coast Inverse
(factory default value) is selected in Terminal 27, a connection to +24V is necessary to enable start.
NB!
For detailed parameter descriptions, please see the following section on
Commonly Used Parameters - Explanations
.
8.1.3. Q1 My Personal Menu
Parameters defined by the user can be stored in Q1 My Personal Menu.
Select
My Personal Menu
to display only the parameters, which have been pre-selected and programmed as personal parameters. For example, a pump
or equipment OEM may have pre-programmed these to be in My Personal Menu during factory commissioning to make on site commissioning / fine tuning
simpler.. These parameters are selected in par. 0-25
My Personal Menu
. Up to 20 different parameters can be defined in this menu.
Q1 My Personal Menu
20-21 Setpoint 1
20-93 PID Proportional Gain
20-94 PID Integral Time
8.1.4. Q2 Quick Setup
The parameters in Q2 Quick Setup are the basic parameters which are always needed to set-up the frequency converter to operation.
Q2 Quick Setup
Parameter number and name
Unit
0-01 Language
1-20 Motor Power
kW
1-22 Motor Voltage
V
1-23 Motor Frequency
Hz
1-24 Motor Current
A
1-25 Motor Nominal Speed
RPM
3-41 Ramp 1 Ramp Up Time
s
3-42 Ramp 1 Ramp Down Time
s
4-11 Motor Speed Low Limit
RPM
4-13 Motor Speed High Limit
RPM
1-29 Automatic Motor Adaptation (AMA)
8. How to programme the frequency converter
VLT
®
AQUA Drive
Operating Instructions
64
MG.20.M5.02 - VLT
®
is a registered Danfoss trademark
8
