Figure 4-258 Compressor Monitor Tool
Table 4-46 Bearing Amperage Nominal Ranges
Bearing Position
Force Range
Axial Force
-1.5 to 1.5 Amp (TTS300 & TGS230 = -2 to 0 Amp)
Front X Force
-1.5 to 1.5 Amp
Front Y Force
-1.5 to 1.5 Amp
Rear X Force
-1.5 to 1.5 Amp
Rear Y Force
-1.5 to 1.5 Amp
4.29.4 Bearing Power Feedthrough Removal and Installation
The steps depicted in this section will apply to either the front or rear feedthrough.
4.29.4.1 Bearing Power Feedthrough Removal
1. Isolate compressor power as described in Section 1.8 Electrical Isolation on page 22.
2. Isolate the compressor and recover the refrigerant according to industry standards. Refer to Section 3.1
Refrigerant Containment on page 41.
3. Remove the Service Side Cover. Refer to Section 4.1.3.1 Service Side Cover Removal and Installation on
4. Pull the Serial Driver Module out of its slot. Make sure you do not damage the connector pins. Keep the
module in a safe place. Refer to Section 4.26.4 Serial Driver Removal and Installation on page 218.
NOTE
Refer to 1.9 Handling Static Sensitive Devices for proper ESD handling of electronic components.
M-SV-001-EN Rev. H-1/23/2023 Page 233 of 294
Summary of Contents for Turbocor TT Series
