Danfoss Turbocor TT Series, Service Manual, Page: 146 / 294

Figure 4-148 SCR Temperature Sensor Connector - TTS300/TGS230
4. Remove the SCR Temperature Sensor from the SCR Cooling Manifold. Refer to Figure 4-149 SCR
Temperature Sensor Removal -TTS300/TGS230.
• • • CAUTION • • •
Be careful to not damage the wire exiting the SCR Temperature Sensor during removal.
Figure 4-149 SCR Temperature Sensor Removal -TTS300/TGS230
4.18.2.8 SCR Temperature Sensor Removal - TTS/TGS/TTH/TGH Rev. F and Earlier (Except TTS300/TGS230)
1. Disconnect the Soft Start AC wires from the AC Bus Bars.
2. Remove the Terminal Block and AC Bus Bars as an assembly. Refer to Section 4.11.2.3 3-Phase Main
Voltage Input Terminal Block Removal - TTS/TGS/TTH/TGH (Except TTS300/TGS230) on page 103.
3. Remove the Capacitor and DC Bus Assembly. Refer to Section 4.21.4.2 DC Capacitor Bus Bar Assembly
Removal - TTS/TGS/TTH/TGH (Except TTS300/TGS230) on page 170.
4. Remove the SCR Temperature Sensor cable from under the DC Bus Bar Assembly from the discharge
side of the compressor. Refer to Figure 4-150 SCR Temperature Sensor Connector - TTS/TGS/TTH/TGH
Rev. F and Earlier (Except TTS300/TGS230) on page 147.
Page 146 of 294 - M-SV-001-EN Rev. H 1/23/2023