Danfoss Turbocor TT Series, Service Manual, Page: 89 / 294

Figure 4-59 Worm Gear Removal
10. Remove the snap ring from the worm gear shaft. Refer to Figure 4-60 Large Worm Gear Bearing for this
and the following step.
11. Remove the upper (large) bearing from the worm gear.
Figure 4-60 Large Worm Gear Bearing
12. Remove the four (4) M6x55 fasteners that retain the IGV Throat assembly and lift the entire assembly
from the IGV Housing. Refer to Figure 4-61 IGV Throat Removal.
Figure 4-61 IGV Throat Removal
M-SV-001-EN Rev. H-1/23/2023 Page 89 of 294