FCM 300 Series
MG.03.B6.2G - VLT is a registered Danfoss trademark
LCP-2 Functions
The functions of the control panel can be divided
into three groups:
●
display
●
keys for changing program parameters
●
keys for local operation
All data is indicated by means of a 4-line alpha-
numeric display, which in normal operation is able to
show 4 measurements and 3 operating conditions
continuously. During programming, all the
information required for quick, effective parameter
Local Control
The LCP-2 is an optional control panel for
programming and monitoring the FCM 300 unit.
NOTE:
The VLT 5000 Series LCP (part #175ZO401) can not
be used with the FCM 300. However, the LCP-2
(part #175NO131) can be used with all VLT 5000,
VLT 2800 and FCM 300 Series units.
LCP-2 installation
The LCP-2 is connected to the X100 terminals (1-4).
For more information, see separate instruction
manual MI.03.AX.YY.
Display
The LCD-display is back-lit with 4 alpha-numeric
lines. The display also shows the direction of motor
rotation with an arrow, the active set-up, and the
set-up currently being programmed (can be different
than the active set-up).
12345678901234567890
12345678
12345678901234567890
12345678901234567890
1st line
2nd line
3rd line
4th line
1st line
shows up to 3 measurements continuously
in normal operating status or a text which explains
the 2nd line.
2nd line
shows a measurement with related unit
continuously, regardless of status (except in the
case of alarm/warning).
■
■
Operation
Setup of the FCM 300 will be displayed. As a
supplement to the display, there are three LEDs for
voltage, warning and alarm.
All program parameters of the FCM 300 can be
changed immediately from the control panel, unless
this function has been blocked via parameter 018.
3rd line
is normally blank and is used in the menu
mode to show the selected parameter number or
parameter group number and name.
4th line
is used in operating status for showing a
status text or in data change mode for showing the
value of the selected parameter.
An arrow indicates the direction of rotation
of the motor. Furthermore, the Setup
which has been selected as the Active
Setup in parameter 004 is shown. When
programming another Setup than the
Active Setup, the number of the Setup
which is being programmed will appear to the right.
This second Setup number will flash.
LEDs
At the bottom of the control panel is a red alarm
LED and a yellow warning LED, as well as a green
voltage LED.
red yellow green
■
7-5
