Info: Connect accordingly
Info: Setup completed
After completing setup, choose to re-run wizard or start
application. Here we can select the following options:
•
Re-run wizard
•
Go to main menu
•
Go to status
•
Run AMA - Note this is a reduced AMA if
compressor application is selected and full AMA if
single fan and pump is selected.
•
If condenser fan is selected in application NO
AMA can be run.
•
Run application- this mode starts the drive in
either hand / local mode or via an external
control signal if open loop is selected in an earlier
screen
The Application Guide can be cancelled at any time by
pressing “Back”. The Application Guide can be re-entered
through the Quick Menu:
When re-entering the Application Guide, the user will be
asked to keep previous changes to the factory setup or to
restore default values.
NOTE
If the system requirement is to have the internal pack
controller for 3 compressors plus by-pass valve connected,
there is the need to specify AKD 102 with the extra relay
card (MCB105) mounted inside the drive.
The bypass valve must be programmed to operate from
one of the extra relay outputs on the MCB105 board.
This is needed because the standard relay outputs in the
AKD 102 are used to control the compressors in the pack.
Application Guide
ADAP-KOOL
®
Drive Operating Instructions
16
MG.11.L4.02 - ADAP-KOOL
®
Drive
3
3
