Dalsa Spyder2 S2-1-40 Series, User Manual

Page: 63 / 77

63 Spyder2 User’s Manual
03-32-10091-04 DALSA
B3 Camera Parameter Screen
You can read current camera settings with the
gcp
command. The table below lists the
settings displayed on the gcp screen with sample values, along with a description of some
of these settings:
GCP Screen Desctiption
GENERAL CAMERA SETTINGS
Camera Model No.: S2-xx-xxxxx
Camera model number.
Camera Serial No.: xxxxxxxxx
Camera serial number.
Sensor Serial No.: xxxxxxxxx
Sensor serial number.
Camera Network ID: x
Camera network id set with the
sci
command.
Network Message Mode: disabled
Displays whether network
messages are enabled or
disabled. Set with the
snm
command. See B1 Networking
Mode for details.
Firmware Design Rev.: xx-xx-xxxxx-xx
Firmware design revision
number.
DSP Design Rev.: xx.xx
DSP design revision number.
SETTINGS FOR UNCALIBRATED MODE:
Analog Gain (dB): +0.0
Analog gain value set with the
sg
and
cao
commands.
Available only in uncalibrated
mode (
svm 0
).
See section 3.13 Setting Gains
for details.
Analog Offset: 308
Analog offset value set with the
sao
and
cag
command. The
cag
command is available only
in uncalibrated mode (
svm 1
).
See section 3.12 Optimizing
Offset Performance for details.
SETTINGS FOR CALIBRATED MODE:
Analog Gain (dB): +0.0
Analog gain value set with the
sg
or
ccp
command. The
ccp
command is available only in
calibrated mode (
svm 1
). See
sections 3.13 Setting Gains and
White Light Calibration (page
32) for details.
Analog Offset: 0
Analog offset value set with the
sao
or
ccf
command. The
ccf
command is available only in
See the following section for
a complete command list.