Matrix PS System Installation and Commissioning Guide
|
159
Dali Wireless Proprietary and Confidential | DW-MAN-036 Rev 06
No Link
For optical ports:
There is a problem with the optical fiber between an hdHost PS and remote, or
between remotes.
RF modules and SFP are deactivated to prevent damaging optical signals from
being passed over the fiber.
Repair the fiber link, following all safety procedures for working with optical fiber.
Click
No Link
to place the port in Standby, and then click
Standby
again to
activate. If the No Link status persists, contact Dali Customer Service.
13.8
Placing RF Modules or Optical Ports in
Standby
You can deactivate the signal path for each frequency band by placing RF modules and
optical ports in Standby.
RF modules are placed in Standby for configuration, software upgrades, module
replacements, and system restarts. Optical ports are placed in Standby for safety
reasons, if a port is not being used, and to clear any associated alarms if the SFP is not
connected to optical fiber.
You cannot deactivate optical port O1 on a remote because it
provides the only digital path to an upstream host or other
remote.
To place an RF module in Standby:
1. Select the airHost PS or hdHost PS in the system tree.
2. Click
to display the Band Information view, or click the gray bar. The RF Signal
Path button is blue and labeled Active.