Daikin SUT00D4016-30, Operating Manual

Page: 93 / 99

PIM00413
13-10
13.5
Oil filling port (air breather) maintenance procedure (only for unit type SUT06, SUT10)
13.5.1
Removing method
The cap can be easily removed by turning it counterclockwise by hand.
13.5.2
Cleaning method
Blow air onto the filter to blow off dust accumulated on/adhering to the filter.
Remove dust from inside of the strainer cylinder.
13.5.3
Mounting direction
Mount the cap by turning it clockwise by hand until it stops.
WARNING

During air blow, wear protective goggles to prevent accumulated substances or dust from touching your eyes.
13.6
Suction strainer maintenance procedure (only for unit type SUT06, SUT10)
13.6.1
Removing method
① After placing the oil receiving pan under the oil-drain port and
opening the oil-drain plug (Rc1 / 2), drain all the hydraulic oil in the
tank completely.
②
After draining all the hydraulic oil in the tank, close the oil-drain
plug again by seal tape. (Tightening torque: 64.0 ~ 70.0 N·m)
③ After draining hydraulic oil completely, remove the nuts (M8: 12
pieces) from the cleaning door cover, and remove the cover from
the cleaning door.
④ Loosen the suction strainer by monkey wrench, and remove it.
( Hexagon nut, Width across flats: 41 mm)
13.6.2
Cleaning method
Blow air onto the filter to blow off dust accumulated on/adhering to the
filter. Remove dust from inside of the strainer cylinder.
13.6.3
Reassembling
After cleaning is completed, reassemble the suction strainer. Follow the removing procedure in reverse.
(Suction strainer: Tightening torque 39.0 N · m; Cleaning palate nut: Tightening torque 9.0 ~ 10.0 N · m)
After reassembling is completed, conduct the test run procedure according to "Chapter 10 Test Run" to make sure
that the hydraulic unit normally operates.
WARNING
 During air blow, wear protective goggles to prevent accumulated substances or dust from touching your eyes.
◎ Cap
◎
Strainer
Oil port and air breather
Oil-drain plug (Rc1/2)
Nut
(M8：12pieces)
Suction
strainer