Daikin Super Multi Plus E-Series BPMKS967B2B, Service Manual

Page: 324 / 492

SA Indoor Unit - FFQ, FCQ, FDBQ, FBQ, FHQ Series SiBE18-821_C
312 Operation Manual
DISPLAY “ ” “ ” “ ” “ ”
“ ” (OPERATION MODE)
DISPLAY “ ” (SIGNAL
TRANSMISSION)
This display shows the current
OPERATION MODE. For cooling only
type, “
” (Auto) and “ ” (Heating)
are not installed.
English 4
2.
1
2
3
This display shows the set temperature.
4
5
Refer to page 9.
6
The display shows the set fan speed.
7
8
ON/OFF BUTTON
9
FAN SPEED CONTROL BUTTON
10
TEMPERATURE SETTING BUTTON
11
PROGRAMMING TIMER BUTTON
12
TIMER MODE START/STOP BUTTON
Refer to page 10.
13
TIMER RESERVE/CANCEL BUTTON
Refer to page 10.
14
AIR FLOW DIRECTION ADJUST BUTTON
Refer to page 9.
15
OPERATION MODE SELECTOR BUTTON
16
FILTER SIGN RESET BUTTON
17
18
EMERGENCY OPERATION SWITCH
NAMES AND FUNCTIONS
OF THE OPERATING
SECTION (Fig. 1, 2)
This lights up when a signal is being
transmitted.
DISPLAY “ ” (SET TEMPERATURE)
DISPLAY “ ”
(PROGRAMMED TIME)
This display shows PROGRAMMED
TIME of the system start or stop.
DISPLAY “ ” (AIR FLOW FLAP)
DISPLAY “ ” “ ” (FAN SPEED)
DISPLAY “ ”
(INSPECTION/ TEST OPERATION)
When the INSPECTION/TEST
OPERATION BUTTON is pressed, the
display shows the system mode is in.
Press the button and the system will
start. Press the button again and the
system will stop.
Press this button to select the fan
speed, HIGH or LOW, of your choice.
Use this button for SETTING
TEMPERATURE (Operates with the front
cover of the remote controller closed.)
Use this button for programming
“START and/or STOP” time. (Operates
with the front cover of the remote
controller opened.)
Press this button to select OPERATION
MODE.
Refer to the section of MAINTENANCE
in the operation manual attached to the
indoor unit.
INSPECTION/TEST OPERATION
BUTTON
This button is used only by qualified
service persons for maintenance
purposes.
This switch is readily used if the remote
controller does not work.