Daikin EKOMB22AAV1H, Installation Instructions Manual

Page: 42 / 448

Daikin Europe NV
43
c Minimum rpm CH 30 30 30 Settings reach 20 – 50%
c. Minimum capacity modulating CH pump 40 40 40 Setting reach 15 to set value par. 3.
d Minimum rpm hot water 30 25 25 Settings reach 20 – 50%
E Min. leaving water temperature at OT
(OpenTherm) or RF thermostat 30 30 30 Settings reach 10 – 60°C
E. Reaction OT and RF room thermostat 1 1 1 0= do not respond to hot water request if requested temperature
is lower than the set value par. E
1= respond to hot water request with minimum leaving water
temperature limited to set value par. E
2= respond to hot water request with maximum leaving water
temperature (on/off function)
3= Low load controlled by Open Therm room thermostat
enabled
F
Start rpm CH 70 60 50 Settings reach 40 – 99% of the set maximum rpm
F. Start rpm hot water 70 60 50 Settings reach 40 – 99% of the set maximum rpm
h
Max. rpm fan (* 100 rpm) 45 46 46 Settings reach 40 – 50 (factory setting)
This parameter can be used to set the maximum rpm
J Not applicable - - - Not applicable
n Regulated temperature during boiler
operation (Ta)
85 85 85 Setting reach 60°C - 90°C
L Legionella protection 0 0 0 Not applicable (for Solo boilers with external DHW tank only)
n. Hot water temperature at Comfort/Eco 0 0 0 Setting reach: 0 or 40°C – 60°C
0= reheating temperature is equal to hot water temperature
O. Wait time CH request response 0 0 0 Settings reach 0 – 15 minutes
o Waiting time CH operation after hot water
operation 0 0 0 Settings reach 0 – 15 minutes
o. Number of eco days 3 3 3 Settings reach 0, 1 - – 10
0 = Comfort function controllable by Open Therm room
thermostat
1
– 10 number of eco days
P Anti-recycling time during CH operation 5 5 5 Minimum switch off time on CH operation
Can be set to 0 - 15 minutes
P. Reference value hot water 2436 3036 36 0 = Flow switch applicable
24 = EKOMB22AAV1H
30 = EKOMB28AAV1H
36 = EKOMB33AAV1H
q Summer mode 0 0 0 0 = Summer mode deactivated
1 = Summer mode to be activated by button
(code in display : Su)
2 = Summer mode to be activated by button
(code in display : So)
3 = Summer mode to be activated by button
(code in display : Et)
r Heating curve coefficient 0 0 0 Not applicable