C
ONNECTION
OF
E
XTERNAL
E
QUIPMENT
C
ONNECTION
C
HAPTER
4
4-14
1.
Check that input power is turned off with the disconnect switch connected to the welding power
source.
2.
Remove the attaching screws and open the cover for external connection.
3.
Include a cutting in a cross mark at the blind bush using a knife and pass the cable through.
●
Process any given blind bush among the several available types.
4.
Connect the cable to the terminal for external connection.
●
Strip the cable cover by 25/64 to 7/16" (10 to 11 mm) from the end while pressing the button on the
terminal block and insert the cable.
5.
Check the wiring and place the cover for external connection back to the welding power source.
Strip the cable cover by
25/64 to 7/16" (10 to 11 mm)
Terminal block
Button
Cable
(vinyl)
Blind bush
Attaching screw
Attaching
screw
Cover for external connections
Summary of Contents for OTC WB-P400
