Daihen OTC WB-P400, Owner'S Manual

Page: 123 / 158

7-11
Chapter 7 Administrator F
unctions
D
ATA
B
ACKUP
(U
TILIZATION OF DATA
)
A
DMINISTRATOR
F
UNCTIONS
C
HAPTER
7
The internal function setting data will be output below the JOB Nos. (registration Nos.)
T I P S
• It is not possible to separately save the welding condition data recorded in memory and the
internal function setting data. Both of the data will always be written in the
"DAIHEN_OTC_WELDING_PARAMETER.CSV" file.
• When importing the backup data to the welding power source, both or either of the data
above can be imported at one time.
"ALL": Welding condition data recorded in Internal function setting data
"1": Welding condition data recorded in memory
"2": Internal function setting data
Ｑ
pre_sens_slp
[Squeeze]
detection
sensitivity
(reserved)
-
ＡＱ
PerIset (reserved) -
Ｒ
pre_sens_cnst - -
ＡＲ
PreIsetPer (reserved) -
Ｓ
pls_pki_adj
Pulse peak current
fine adjustment
1(A)
ＡＳ
CreIsetPer (reserved) -
Ｔ
pls_pkt_adj
Pulse peak time
fine adjustment
0.1(ms)
ＡＴ
TsCrickIset
Torch switch
current adjustment
0/1(OFF/ON)
Ｕ
pls_bsi_adj
Base current fine
adjustment
1(A)
ＡＵ
CriIsetStep1
Single click
adjustment value
1(A)
Ｖ
lpls_pki_adj
L pulse peak
current fine
adjustment
1(A)
ＡＶ
CriIsetStep2
Double click
adjustment value
1(A)
Ｗ
lpls_pkt_adj
L pulse peak
time fine
adjustment
0.1(ms)
ＡＷ
WModeTblNo Welding table No. (*3)
Ｘ
lpls_bsi_adj
L base current
fine adjustment
1(A)
ＡＸ
chksum Checksum
Checksum
data
Ｙ
wave_feed_ad
j
Wave pulse
feed amplitude
1(%)
ＡＹ
- - -
Ｚ
ctrl
Sequence
information
(*1)
ＡＺ
- - -
*1: Crater sequence and other information is recorded.
*2: Wire diameter, material, shield gas and other process information is recorded.
*3: Information of welding parameter table is recorded.
Column Item Description Unit Column Item Description Unit
Function setting data