Dahua DHI-ARC3008C, Installer Manual

Page: 48 / 111

Alarm Control Panel Installer Manual
47
Item Setting
If you press to confirm the option, you will exit and the output will
immediately take on the selected polarity.
SYSTEM Outputs
The system outputs follow on from general system conditions regardless of the areas.
Table 1-20 System outputs programming
Item Setting
TYPE
SIREN ALARM: Follows the generic alarm condition and the timing is

in according to SYSTEM FUNCTIONS setting.
SYSTEM TAMPER: Follows Control Panel tamper condition.

SIREN TAMPER: Follows Siren tamper condition.

KEYPAD TAMPER: Follows Keypad tamper condition.

COM1 TROUBLE: Follows a fault condition on the COM1 generated

by the bus modules.
WALK TEST: Follows the placing of the Control Panel in WALK TEST

mode.
TECHNICIAN: Follows the entry of the TECHNICIAN into

programming.
CODE ERROR: This type of output activates when the counter for the

number of false codes entered reaches the parameter set in SYSTEM
FUNCTIONS. The duration of the output activations is 3 minutes.
COM. BUSY: This type of output follows telephone communication in

progress.
TROUBLES: Follows a failure of troubles that include a loss of PSTN

LINE, a loss of GSM telephone line, antenna tamper, main power
supply loss, battery loss, low battery voltage, SIM expiry, time
abnormality.
POLAR
Select the output polarity.
DIRECT

REVERSE

AREAS 1.27
After entering the Installer Menu, press and to scroll up and down until you reach the Step 1
AREAS menu. See Figure 1-24.
Areas Figure 1-24
Press to enter the programming mode. Step 2