Dahua DHI-ARC3008C, Installer Manual

Page: 43 / 111

Alarm Control Panel Installer Manual
42
1.26.2 Configuring OUTPUT Categories
On the CATEGORIES submenu, press or to select the output category from AREAS, ZONES,
LINK, GENERIC, or SYSTEM, and then press to enter the programming mode of output that you
selected.
Press and to alter the options. Press to confirm the setting and move to the next
submenu.
By entering the OUTPUTS menu when the LCD display shows the name of output, it is possible to
manually activate the output to test its operation: Press + 1 (F1), the ACTIVE interface is shown. See
Figure 1-23.
Active Figure 1-23
The text ACTIVE is flashing. The output activates and remains activated manually until the or
is pressed. The TECHNICIAN then can manually test all the system outputs.
AREA Outputs
Table 1-16 Areas outputs programming
Submenu Setting
TYPE
AREA ON: Follows Area(s) armed status. 
AREA OFF: Follows Area(s) armed status. 
PART1 ON: Follows Partition 1 armed status. 
PART2 ON: Follows Partition 2 armed status. 
EXIT TIME: Follows the exit delay time for the assigned area. In the 
case of multiple areas, it follows the longest period.
ENTRY TIME: Follows the entry time for the assigned area. In the 
case of multiple areas, it follows the longest period.
IN AND OUT DELAY TIME: Follows both the exit time and entry time 
for the assigned area.
FORCED ARM: Follows forced arming with unready zones. This 
function is useful for notifying that TIMER arming has been provided
with a certain number of NOT READY zones which are therefore
automatically bypass from arming.
CHIME: Follows the CHIME alarm condition in a chime zone (this can 
be one or more areas).
ZONE BYPASS: Follows the existence of BYPASSED zones. 
ZONE TAMPER: Follows an alarm condition due to the activation of a 
wired or wireless zone tamper (this can be one or more areas).