DAF 95XF, Maintenance Manual

Page: 155 / 188

95 XF
series Removal and installation
EXPLANATORY NOTES ON THE MAINTENANCE ACTIVITIES
4-35
7. Slide the appropriate centring flange (D) on
the centring spindle (E).
8. Fit the locking plate (C) and the nut (B) on
the centring spindle (E).
9. Align the centring flange (D) on the outer
race of the outer wheel bearing and
hand-tighten nut (B) (max. 20 Nm). The
centring spindle (E) must be installed in the
hub (2) free of play.
Note:
Fit the dummy sensor ring (G) to the
draw-in flange (H) if the wheel hub (2) is
not equipped with a sensor ring (5).
Fit the draw-in flange (H) without the
dummy sensor ring if the hub (2)
does have
a sensor ring (5).
10. Position the seal (4) in front of the hub with
the seal lip pointing to the outside of the
hub. Slide the draw-in flange (H) over the
centring spindle (E) against the seal (4).
11. Fit the locking plate (I) and the nut (K).
12. Push the seal (4) evenly into the hub (2)
using the nut (K). In the case of a hub with
sensor ring (5) the oil seal should be
pressed in until draw-in flange (H) abuts the
sensor ring (5). In the case of a wheel hub
without sensor ring (5) the oil seal should
be pressed in until the dummy sensor
ring (G) abuts the hub rim.
13. Remove the special tool.
14. Apply grease to the sealing lips of the oil
seal (4).
15. Install the hub on the axle journal.
3
F
H
5 4
S7 00 182
5
 200424