DAF 95XF, Manual, Page: 56 / 312

1
INTERNAL CAB COMPONENTS
Inspection and adjustment
95 XF
series
3-4
7
Adjusting roller sun blind, model II
Notes:
- The spring tension of the roll-up mechanism
must be adjusted on the
other side than the
side where the operating lever is located.
- The attachment screws (4) of the side
cover may either be cross head screws or
torx screws.
1. Loosen the socket head screw (1) until the
guide bracket (2) with end stop (3) can be
taken out of the side cover.
Note:
Make sure that the side cover is pressed
against the roller sun blind when removing
the attachment screws. If the side cover is
taken too far from the roller sun blind, the
internal spring of the roll-up mechanism will
fully expand.
2. Remove the attachment screws (4) from
the side cover (if these are cross head
screws, remove them e.g. with a bent
screw driver).
K1 01 452
4
2
3
1
3. Take the side cover so far from the roller
sun blind that the side cover is able to turn.
Adjust the spring tension of the roll-up
mechanism.
4. Press the side cover fully against the roller
sun blind and fit the attachment screws (4).
5. Fit the guide bracket (2) with end stop (3) in
the side cover. Tighten the socket head
screw (1). Press the end stop (3) in the side
cover.
6. Check that the roll-up mechanism is
working properly.
K1 01 453
2
ᓻ 0209