DAF 95XF, Manual, Page: 53 / 312

1
95 XF
series Inspection and adjustment
INTERNAL CAB COMPONENTS
3-1
3. INSPECTION AND ADJUSTMENT
3.1 INSPECTION, STEERING COLUMN SETTING VALVE
1. Check if the height and the angle of the
steering column can be adjusted after the
switch (convex top) is pressed.
2. Check whether the adjustment mechanism
is securely locked again when operating the
bottom of the switch.
3. Check whether the operating valve is bled
after the switch has been operated. Press
the convex side of the switch and wait a few
seconds until the adjustment mechanism is
blocked again.
4. If this is not the case, check that no air pipe
is trapped. If not, replace the valve (switch).
D000339
3.2 INSPECTION, FASTENING OF UNIVERSAL JOINT TO STEERING BOX
INPUT SHAFT
Inspection, fastening of universal joint to
steering box input shaft
1. Check the universal joint for noticeable play.
If noticeable play is detected, the affected
part must be replaced.
2. Check whether there is any noticeable play
between the spline connection of the
universal joint and the steering box input
shaft. If noticeable play is detected, the
splines on the universal joint and those on
the input shaft need to be checked for wear.
If there is some wear, the affected part
must be replaced.
If there is noticeable play but the parts are
not worn, the attachment bolt and nut must
be replaced. Tighten the attachment bolt
and nut to the specified torque. See
“Technical data”.
K1 01 530
2
ᓻ 0209