DAF 95XF, Manual, Page: 174 / 312

1
EXTERNAL CAB COMPONENTS
Removal and installation
95 XF
series
4-48
Pre-treating the plastic window when
re-using the window
Check the length and width of the window (when
re-using the window). The length should be no
more than 1860 mm and the width no more than
160 mm.
1. If the window has been used before,
remove as much of the glue remnants as
possible. A thin layer of glue may remain.
2. On the inside of the window, tape up the
edges of the area to be glued with thin,
smooth, adhesive tape.
3. Those window areas which are to be glued
should be cleaned beforehand with a
non-pilling, clean, white cloth moistened
with the specified cleaning agent, see
”Technical data” and then sanded with the
specified abrasive, see ”Technical data”.
The sanded surface should be cleaned
once again with the specified cleaning
agent and allowed to dry for a minimum of
10 minutes at room temperature. Check
whether the surface is free of abrasives and
other impurities and repeat the cleaning
process if necessary.
4. Use a brush to apply a single thin, covering
layer of the specified primer, in accordance
with the supplier’s instructions, see
”Technical data”. Allow this layer to dry for
at least 30 minutes but no more than 24
hours at room temperature.
4
ᓻ 200345